#1
Which of the following is NOT a primary hazard associated with rigging and lifting operations?
Electrocution
Overloading
Slips, trips, and falls
Noise pollution
#2
What is the primary purpose of conducting a pre-lift safety meeting?
To assign blame in case of accidents
To discuss the weather
To review the lift plan and potential hazards
To make sure everyone has their safety gear on
#3
What is the purpose of a tagline during a lifting operation?
To indicate the weight of the load
To provide additional support to the load
To control the swinging or rotation of the load
To provide communication between the ground and the operator
#4
What does OSHA stand for?
Occupational Safety and Hazard Administration
Occupational Safety and Health Administration
Office of Safety and Health Administration
Office of Safety and Hazard Administration
#5
What is the primary risk associated with overloading rigging equipment?
Reduced efficiency
Increased wear and tear
Equipment failure and potential accidents
Decreased productivity
#6
What is the recommended inspection frequency for rigging equipment?
Every 3 months
Every 6 months
Every year
Every 2 years
#7
What does the term SWL stand for in the context of rigging and lifting?
Safe Working Limit
Standard Weight Load
Single Wire Lifting
Suspension Weight Limit
#8
Which of the following is NOT a factor to consider when selecting rigging equipment?
Load weight and size
Material handling method
Environmental conditions
Cost of equipment rental
#9
What is the recommended angle between the sling and the load when using a vertical hitch?
45 degrees
60 degrees
90 degrees
120 degrees
#10
When should rigging equipment be replaced?
When it has visible signs of wear or damage
After every use
When it reaches a certain age, regardless of condition
Only when it fails during operation
#11
What is the correct hand signal for 'lower the load' in rigging operations?
Fist raised overhead
Pointing downwards with one finger
Thumb pointing downwards
Waving both hands above head
#12
What is the main advantage of using synthetic slings over chain or wire rope slings?
They are more durable
They are less expensive
They are less prone to damage to the load
They are not affected by environmental conditions
#13
In a tandem lift, what precaution should be taken regarding the load's center of gravity?
It should be positioned directly above the rigging equipment
It should be positioned slightly off-center
It should be positioned as far away from the rigging equipment as possible
It does not matter as long as both lifting devices are synchronized
#14
What is the purpose of a spreader bar in rigging?
To increase the weight capacity of the lifting equipment
To distribute the load more evenly across multiple lifting points
To provide a connection point between rigging components
To measure the tension in the lifting cables
#15
What is the purpose of load testing in rigging and lifting operations?
To determine the weight of the load
To ensure the rigging equipment can handle the intended load
To measure the tension in the lifting cables
To verify the accuracy of the crane's weight scale