#1
Which of the following is a basic principle of rigging safety?
Ignoring weight limits
Regularly inspecting equipment
Using equipment without proper training
Skipping safety checks
#2
What should be done before using rigging equipment?
Nothing, equipment is ready to use out of the box
Inspect for damage or wear
Assume it's safe if it was used recently
Clean it thoroughly
#3
What is the primary purpose of a shackle in rigging?
To provide illumination
To secure loads
To measure weight
To increase friction
#4
What is the recommended way to communicate during rigging operations?
Use hand signals
Yell loudly
Use any language
Stay silent
#5
What is the primary function of a snatch block in rigging?
To increase tension
To prevent accidents
To change the direction of a line
To store rigging equipment
#6
What does OSHA stand for in relation to rigging safety?
Occupational Safety and Health Administration
Operational Standards for Heavy Equipment Association
Overhead Safety and Hazard Awareness
Operating Standards for Hazardous Activities
#7
What is the primary purpose of a spreader beam in rigging?
To confuse workers
To secure loads
To decrease stability
To increase friction
#8
What is the purpose of a tagline in rigging?
To decorate the equipment
To mark weight limits
To control the load's rotation
To carry important information
#9
What is the maximum weight capacity of rigging equipment determined by?
Manufacturer specifications
Personal estimation
Weather conditions
Trial and error
#10
What does SWL stand for in rigging?
Safe Working Load
Strong Weight Limit
Secure Weight Load
Safety Working Load
#11
When should you use a spreader bar in rigging?
To decrease stability
To lift heavy loads
To obstruct the view
To speed up the process
#12
What is a common type of hitch used in rigging to attach a load to a hook?
Clove hitch
Buntline hitch
Sheet bend
Square knot
#13
What is the primary purpose of a rigging plan?
To increase complexity
To document safety procedures
To decrease communication
To limit equipment usage
#14
What is the purpose of a deadman in rigging?
To mark weight limits
To control the load's rotation
To provide support
To carry important information
#15
What should be done if rigging equipment shows signs of wear or damage?
Continue using it, but with caution
Dispose of it immediately
Repair it by oneself
Get it inspected and repaired by a qualified person
#16
What is the recommended way to attach a load to rigging equipment?
Loosely
With duct tape
Using the appropriate attachments and hardware
By hand
#17
What is the role of a competent person in rigging operations?
To oversee unsafe practices
To ignore safety regulations
To supervise and ensure safety
To minimize communication
#18
What is the role of a signal person in rigging operations?
To operate equipment
To provide hand signals and communicate with the operator
To oversee the rigging plan
To ignore safety protocols
#19
What should be done if rigging equipment is exposed to corrosive substances?
Nothing, it won't affect the equipment
Clean and inspect it thoroughly
Use it immediately without any concern
Dispose of it immediately